benjaminvelure

I'm still new to Vray and I have t admit it is giving me a head ache most of the time. For some reason I can't change the subdivisions for the reflection layer in certain materials. A glass material in this case. Any clues?

Thanks a lot for the input! Showing it to someone who hadn't seen the 3D-modell I realized it is actually a bit hard to make out the shape of the building from the chosen angle. Tidying up the foreground is probably good advice too!

I'm quite new to rendering an tying to figure out how to get a decent output without ridiculous render times. But the many settings are a bit overwhelming. Would appreciate a lot if you could take a look at my settings and give some input on which parameters might be overkill. My output is 3000 wide. It seems like my render time increased dramatically when I introduced materials with strong(but not very complex i think) displament maps.

That's weird. This one too?

Started learning Vray for Rhino a few months ago and decided to render some of my projects from architecture school. I've done amateur photography for several years, so I'm depending quite a lot on photoshop to get the final result. Note that the timber wall is partially covered with glass to create a trombe wall, hence the reflection. [ATTACH=CONFIG]52431[/ATTACH]