pgoh

Modelled in Max3.1 & rendered in vray

Part of Architectural Showreel. Image ready for verbal abuse. [ July 10, 2002, 07:53 PM: Message edited by: pgoh ]

Just heard the news today that the Korean Player who scored the golden goal has been sacked by his Italian Club. What about that?!

I've been using Epson 1270 for 2 years now and it's worth every cent of it. The only major difference between the 1270 and 1290 (1290 over here in australia) is that 1290 prints full bleed, whereas 1270 leaves a 5mm border. A bit annoying if u intends to joint 4 A3's to make an A1. I've done that a few times as a student cause an A1 colour print here cost A$110 (US$60). But nontheless the best quality (and not too bad for speed) inkjet i've seen and used. Have been thinking of upgrading to 1290 though simply for the full bleed. 1290 cost around A$950 (US$530).

Che, did u subtract the door and windows together or individually? Subtract individually also gives better layer management. Save as dwg. and import as dwg in Viz. Hope that helps.

Thanx for the help guys. I'll start work on one now! cheers

Hi everyone first of all i'd like to congratulate Jeff and the gang on making this the best site for designers. I've just registered five minutes ago, though i've been following the site everyday (no kidding) since last september. I'm a rather newbie to the world of 3d (and 2d for that matter), but i've been working on a project where i need to model (or somehow) get three water fountains into my viz/max model. If there's someone out there who'd like to offer a hand, it'll be very much appreciated. Thanx