Search the Community

Hello I am trying to create a kitchen sink. I have the general shape completed but I want to chamfer the front edges of the kitchen top to give it a round edge. But I have run into a problem with chamfer. The right side gets chamfered properly with 4 sections, as intended but the left side doesn't get chamfered properly. I have attached a jpeg image. As you can see, the left side of the chamfering doesn't get rounded out but instead is cut straight diagonally. Look at the far side (right side), you can see it is rounded. Furthermore, if you look closely, you will notice several vertices lined up along the chamfered area. Why do these "artifacts" appear? Before the chamfering, it was just a straight corner with a single vertex. I have examined all vertices, edges, polygons of this table, but there are no irregularities. I would greatly appreciate any input. Even hints or suspicions would be greatly helpful.

I ran into this problem a few times. I have problem chamfering attached objects. What is the best way to get rid of this kind of problem? Max hadles it as it was to totally different objects. I tried welding vertices, reset xform. I don't know what else I can do. I created this using a spline. Max 2013