Problem with Floor Generator V2.0

[Joe Luckett]

Hi,

 

I've been using floor generator for ages so was delighted to see the arrival of v2.0. However I am having a few problems with it (see screengrab) whereby the floor generator modifier doesn't fill the shape of the spline completely. Does anyone know if there's a reason for this or is it just a bug?

 

Thanks

 

[jonasmotiejunas]

Same here, but it only happens when i change direction angle

[keithhill]

Hi, we are having the same problem here aswell. We have reverted back to version 1 for now.

 

 

Can I confirm are you using the trial version or the full paid version??

 

 

Thanks.

[Joe Luckett]

Hi Keith,

 

No, we bought the full version. I've just read on their Facebook page though that it is a bug and they're sorting it. However, there is a fix for it which works:

- Turn off the floor generator modifier.

- Centre the pivot in the shape.

- Run 'Reset XForm' in the utilities tab.

- Make sure it's below the floor generator in the modifier stack.

- Turn your floor generator back on.