danielizquierdo1 Posted June 25, 2015 Share Posted June 25, 2015 (edited) Hello everyone, I don't know why, but every time I enable the lens effect for V-Ray in Sketchup I end up getting these weird black blotches right after the image finishes rendering/generates the Lens glare and bloom. The image renders fine, but it is only after it generates the glare and bloom effect that i get this. Any idea as to how to avoid these blotches without sacrificing not having the Lens effect on. Edited June 25, 2015 by danielizquierdo1 Link to comment Share on other sites More sharing options...
ryannelson Posted July 3, 2015 Share Posted July 3, 2015 I've run into this problem with Vray for Rhino before. What it turned out to be was that the lens effects are not supported by distributed rendering. If you're not using DR, then i'm not sure... Link to comment Share on other sites More sharing options...
danielizquierdo1 Posted July 6, 2015 Author Share Posted July 6, 2015 Thank you so much Ryan! Yes I am using distributed rendering. I will try to disable that and see if it works. Thanks again much appreciative for the response. Link to comment Share on other sites More sharing options...
rad_thundercat Posted August 8, 2015 Share Posted August 8, 2015 Thank you for posting this, I have the EXACT same problem but with 3ds max. Are bloom and glare not supported for distributed rendering on 3ds max as well? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now